Alfissimo's Front Upper Adjustable control arms-Giulia/QV/GTA/m/Stelvio-ALL (PAIR)

• Get Negative with our Front Upper Adjustable Upper Control Arms- First and Exclusive. 
• Significantly adjust negative camber from -1.70 to -4˚00+/- (these are not designed to adjust less than ~ -1.70)
• Ability to fit 19x10 wheels for square setup using our 17mm spacers. 
• Spherical joint with teflon coating take the place of the rubber bushing. 
  
• Arms are made in Italy- TUV approved. Arms modified by TUV CNC fabricator.
• FK Rod ends-PTFE liner for long use, self lubricating.
• Zinc plated nuts
• Can be used in conjunction with Our Alfissimo Corsa Camber/Caster eccentric bushing without shims.
• Supplied with 8x 2mm shims for fine tuning on the track or during alignment. Set up according to our instructions and fine tune if needed with shims
• PROFESSIONAL SETUP REQUIRED! These can add time to alignment so please account for extra time to dial in. 

Fits: Giulia 2.0L and 2.9L

The first upper adjustable control arm for the Giulia/Stelvio. Designed for us by a IMSA/F1 engineer. We went with an OEM/aftermarket arm modification in order to maintain OEM fitment and look while saving you money. We found the OEM/Aftermarket arms to handle the job very well so there was no reason to fabricate new arms. We have our original set on a car now for 3 years, with mixed track and road use. There is no increase in NVH in the cabin. Handling is significantly improved along tire wear and steering response. 

Below we have all the information on how to adjust the arms. We recommend setting them to desired camber and leaving them. 

We have an estimated track and aggressive street alignment recommendations using the Upper Adjustable control arms. 

FUCA adjustment:

To achieve -2 deg camber, the arms need to be 0.5” shorter than stock (from the outer ball joint to a line through both rod end).  To achieve this the center of the rod end bore needs to be 1.67” from the machined end face of the control arm (not the jam nut), which means that 0.96” of the rod end is threaded into the control arm = 17.5 turns.  The rod ends have 18 threads per inch, so 17.5 threads = turns = 0.97” engaged.

We ship the arms with the rod ends threaded in to be 0.75” shorter than the stock arms which increases negative camber by about 2.25 degrees.  If the stock camber is -0.5 degree, the new camber should be  -2.7 with the arms installed and the front toe reset.   Please note that as the FUCA gets shorter front toe-out increases because the tie-rod is attached to the front upright above the lower ball joint.  So, the front toe needs to be reset to desired spec as part of the FUCA installation process.  The initial camber measurement with the arms installed before the toe is adjusted will change slightly after the toe is reset.

You can fine tune with ½ turn of both rod ends = 0.08 degree camber change,  1 turn of both rod ends = 0.17 degree camber change, and 3 turns of both rod ends = 0.5 degrees camber change.  So, to achieve -1.8 degrees negative camber the rod ends should be installed 1 turn less than the -2 deg setting or 16.5 turns in the arms = 0.92” engaged. 

*All Alfissimo/CORSA Bespoke products are not returnable. These are considered Race products and thus are not a warranty item.