SGW Bypass loom extension leads (12pin and 8pin) for FCA cars. 

At the time of writing, the SGW extension leads are compatible with following makes/models (only the main ones are listed):

Alfa Romeo: Giulia, Stelvio (including face-lift MY2020)

Jeep: Renegade, Compass, Wrangler, Cherokee, Grand Cherokee

Fiat: 500L, 500X, Doblo

Dodge: Challenger, Charger

RAM: 1500

Single SGW harness extension pair leads allow a bit easier re-connecting between SGW and SGW bypass, but mainly minimizes risk of accidental damage or wearing off the original car loom/connectors.

However the recommended setup chosen by most of customers is to use two sets/pairs of the product in series connection, user no longer needs to disconnect from SGW as connecting SGW bypass is done to mid-point between extension looms, so it is much easier and is very low-risk job. 

In Alfa Romeo Giulia using two sets/pairs allows easy connections of SGW bypass though under-steering wheel column opening (see attached photos), and in  Alfa Romeo Stelvio such allows easy enough SGW bypass installation after only removing glasses compartment (~5 minutes job vs. ~1h).

Please review block diagram pictures where we visualize each setup, and make sure you order single with full awareness - we had a few cases already that customers didn't fully noticed the difference and so they were later ordering second sets and so wasting money on second shipment.

Ordering 2 pair is the best solution. 

Instructions:

UIM0003.pdf