DTC Killer by Squadra

When the Powergate is connected, a number of errors are caused, all of which are related to the CAN network. This is unavoidable and does no harm.

During a programming session, the injection computer is brought into an electronic coma (boot mode). All other control units notice this and therefore give an error message. In short, after a programming session, 10 errors were detected. When the ignition is turned off and a few seconds later, nothing of this is visible anymore. But the errors remain stored in the memories of the various control units.

The DTC killer ensures that ALL error messages are erased. The operation is simple. Switch on the DTC killer, plug it into the EOBD connector and wait for the red LED to stop flashing. This takes about 45 sec. Then remove the DTC killer.